Dental Lab Marathon Electric Pol. Foot ON/OFF Control system: 1PC.
Set of 10 pcs Drills Burs. To avoid the problem of speed loose control and maintain long lifespan of this machine, please do turn the. Speed to "min" with the speed controller before start the following operation : push "on"or"off" button. Switching bur running between clockwise and reversed or Switching control between manual and foot pedal. Please remember to make the speed controller zero when switch on or off the machine and when you do Reversible Switching.Attention: The bur for Contra-Angle Handpiece must have a card slot (the diameter of the bur handle: 2.35mm). Compact sized control box with precise smaill & strong micromotor handpiece. Very High-powered and quality 0-35,000rpm. Easily restored back to the original position. Non stage speed system(it's well designed to output from zero to 35,000rpm by using non stage speed system). Right & Left turning ability. Low Speed 22,000-27,000 rpm. The shank of the instrument mounted therein is 2.35 mm. Fastening of the instruments with a turning latch. For any lab or E-type motors.
Working pressure: 0.3MPa (4-hole). 0.25MPa (2-hole) (Measure meter is installed at the end of air motor to measure the air pressure). Dental Lab Steel Carbide Burs for Polishing Teeth Drill Handpiece 2.35mm.
Fit for Dental Handpiece with 3/32 inch collect. The main features of carbide rotary burs. It can be used in processing all kinds of metals(it involved all kinds of Hardened Steel)and nonmetal(such as marble, Jade, bone). The hardness of the workpiece is up to. The small, short-handled grinding wheel can be replaced by it in most part of work without dust pollution.It has high processing quality, high polishing, and can processing various shapes moulds with high precision. It has long service life, 10 times longer than the high speed steel cutter, 200 times longer than the durability of the small grinding wheel. It is not only easy to master, use, but also safe and reliable. Labor intensity can be reduced, and better the working environment.
High economic efficiency, and comprehensive processing cost Can be reduced 10 times around. Carbide rotary burrs are usually driven by hand-held electric, or wind-energy tools (also available on machine tools). The tool must be clamped rightly when using.
It is better to choose reverse milling as cutting type to avoid reciprocating cutting. The work should be to avoid the chip flying. Please wear the protective glasses to avoid scraps flying-out when you are working.Tungsten steel burs are not suitable for bending machines, only suitable for straight machines. The pedal only functions as a switch and cannot be adjusted.
The sale of this item may be subject to regulation by the U. Food and Drug Administration and state and local regulatory agencies. We try our best to reply to your emails as soon as possible, however, due to high volume of daily incoming emails and time zone difference, we may not be able to reply your emails immediately.
Please give us the opportunity to resolve any problem. We understand the concerns and frustrations you might have, and will try our best to resolve the issues. Feedback is very important to us. It is impossible to address issues if we do not know about them!Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount.
Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. This item is in the category "Business & Industrial\Healthcare, Lab & Dental\Medical, Lab & Dental Supplies\Dental Burs, Polishers & Finishers". The seller is "yunchenmeiji001" and is located in this country: US. This item can be shipped to United States.